Juniper-networks T1600 User Manual download pdf (Page 30)

user@host# exit

Tools Required

To upgrade the SIBs, you need the following tools and parts.

■ Electrostatic discharge (ESD) grounding wrist strap

■ Phillips (+) screwdrivers, numbers 1 and 2

Removing a Standard SIB or SIB Version B

To remove a standard SIB or SIB version B, follow this procedure:

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and

connect the strap to one of the ESD points on the chassis. See “Preventing

Electrostatic Discharge Damage” on page 47.

2. Take the SIB offline by using one of the following methods:

■

Press and hold the ONLINE/OFFLINE button on the SIB faceplate for about

five seconds until the OK LED is not lit.

■

Issue the request chassis sib offline command. For example:

user@host> request chassis sib offline slot 0

NOTE: When you bring an active SIB offline, the spare SIB becomes active and

transitions to the Online state.

3. Loosen the captive screws (using a Phillips (+) screwdriver, number 2) on the

ejector handles on each side of the SIB faceplate.

4. Flip the ejector handles outward to unseat the SIB.

5. Grasp both ejector handles, pull firmly, and slide the SIB about three-quarters of

the way out of the chassis.

6. Place one hand underneath the SIB to support it and slide it completely out of

the chassis. Place the SIB on the antistatic mat.

CAUTION: Do not stack hardware components on one another after you remove

them. Place each component on an antistatic mat resting on a stable, flat surface.

30 ■ Upgrading SIBs

T1600 Routing Node Upgrade Guide

1 ... 29 30 31 ... 56

No comments

Juniper-networks T1600 User Manual Page 30