Juniper Networks T1600 User Manual download pdf (Page 18)

CAUTION: Do not substitute a metric nut driver or wrench. A tool that does not fit

the nuts exactly can damage them. If a 7/16-in. tool is not available, use pliers or an

adjustable wrench.

■ Phillips (+) screwdrivers, numbers 1 and 2

■ Flashlight

■ Non-conductive sharp object to set the input-mode switch

■ Wire cutters

Removing a Two-Input 160-A Power Supply

To remove a two-input 160-A power supply, follow this procedure:

1. Switch off the external circuit breakers to the power supply being removed. Make

sure that the voltage across the DC power source cable leads is 0 V and that there

is no chance that the cables might become active during the removal process.

2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and

connect the strap to one of the ESD points on the chassis. See “Preventing

Electrostatic Discharge Damage” on page 47.

Switch both circuit breakers on the power supply faceplate to the off position (O).

Figure 9: Two-Input 160-A Power Supply

NOTE: After powering off a power supply, wait at least 60 seconds before turning it

back on.

4. Remove the clear plastic cover protecting the terminal studs on the faceplate.

18 ■ Upgrading the DC Power Supplies

T1600 Routing Node Upgrade Guide

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 55 56

No comments

Juniper Networks T1600 User Manual Page 18