Juniper Networks T1600 User Manual download pdf (Page 48)

■

You can install any transceiver supported by the PIC. For information about installing

and removing transceivers, see the PIC and Transceiver Installation Instructions.

■

Fiber-optic SFP transceivers:

■

Duplex LC/PC connector (Rx and Tx)

■

Optical interface support—see Table 21 on page 48

■

1000Base-T SFP transceivers:

■

Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45

connector

■

Pinout: MDI crossover

■

Length: 328 ft/100 m

NOTE: Do not install SONET/SDH OC48c/STM16 SFPs in the Gigabit Ethernet port. The port

will not recognize the SFP.

Cables and connectors

Status LED, one tricolor:

■

Off—Not enabled

■

Green—Online with no alarms or failures

■

Amber—Online with alarms for remote failures

■

Red—Active with a local alarm; router has detected a failure

NOTE: The green status LED is lit on the 2-port Gigabit Ethernet IQ PIC when at least one

port is online.

Port LEDs, one per port:

■

Off—Port is down

■

Green—Link is established

LEDs

Table 21: Optical Interface Support for Gigabit Ethernet IQ PICs with SFP

1000Base-LH1000Base-LX1000Base-SXParameter

Single-modeSingle-modeMultimodeOptical interface

SFPSFPSFPTransceiver type

Multivendor

agreement

IEEE 802.3—1998IEEE 802.3—1998Standard

9/125 SMF cable:

43.5 miles/70 km

9/125 SMF cable:

6.2 miles/10 km

62.5/125 or 50/125

MMF cable:

1804.5 ft/550 m

62.5/125 MMF cable:

656 ft/200 m

50/125 MMF cable:

1640 ft/500 m

Maximum distance

1480 through 1580

1270 through 1355

770 through 860 nmTransmitter

wavelength

–3 through +3 dBm–11.5 through –3

dBm

–9.5 through 0 dBmAverage launch power

48 ■ Gigabit Ethernet IQ PICs with SFP

T1600 Internet Routing Node PIC Guide

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 112 113

Comments to this Manuals

No comments

Juniper Networks T1600 User Manual Page 48

Comments to this Manuals

Related products and manuals for Routers Juniper Networks T1600