■
Quality of service (QoS) per channel: weighted round-robin (WRR), random early detection
(RED), weighted random early detection (WRED)
■
Configurable WAN-PHY mode options:
■
loopback
■
mpls
■
path-trace
■
trigger
■
Flexible Ethernet Services Encapsulation
■
802.1q virtual LANs (VLANs)
■
Ethernet OAM 802.1ag continuity check
■
Ethernet OAM 802.3ah (remote loopback is not supported for this PIC)
■
VLAN stacking
■
Channels defined by two stacked VLAN tags
■
Multiple tag protocol identifiers (TPID) support
■
IP service for nonstandard TPID and stacked VLAN tags
■
MAC learning, accounting, and filtering
■
Virtual Router Redundancy Protocol (VRRP) support
Software features
■
You can install any transceiver supported by the PIC. For information about installing
and removing transceivers, see the PIC and Transceiver Installation Instructions.
■
Fiber-optic 10-gigabit small form-factor pluggable (XFP) transceivers:
■
Connector: Duplex LC/PC (Rx and Tx)
■
Optical interface support—See Table 28 on page 64
Cables and connectors
Port LED, one for each port:
■
Off—Port is not enabled
■
Green—Port is online with no alarms or failures
■
Amber—Port is online with alarms for remote failures
■
Red—The router has detected a failure with alarms for local failures
LEDs
10-Gigabit Ethernet LAN/WAN PIC with XFP ■ 63
10-Gigabit Ethernet LAN/WAN PIC with XFP
Comments to this Manuals