Juniper Networks T1600 User Manual download pdf (Page 74)

SONET/SDH OC3c/STM1 PIC

■

JUNOS 8.5 and later (Type 1)

NOTE: Although the illustration shows a multimode PIC, a multimode PIC and a single-mode

intermediate reach PIC are both supported.

Software release

■

Four OC3 ports

■

Power requirement: 0.49 A @ 48 V @ 23.7 W)

Description

■

Multiplexing and demultiplexing

■

Rate policing on input

■

Rate shaping on output

■

Packet buffering, Layer 2 parsing

Hardware features

■

SONET/SDH framing

■

Link aggregation

■

Alarm and event counting and detection

■

Dual-router automatic protection switching (APS)

■

Multiprotocol Label Switching (MPLS) fast reroute

■

Encapsulations:

■

High-Level Data Link Control (HDLC)

■

Frame Relay

■

Circuit cross-connect (CCC)

■

Translational cross-connect (TCC)

■

Point-to-Point Protocol (PPP)

Software features

■

Duplex SC/PC connector (Rx and Tx)

■

Optical interface support—See Table 31 on page 76

NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid

links, take the PIC offline until you are ready to establish a link to another device. For

information about taking a PIC offline, see the request chassis pic offline command in the

JUNOS System Basics and Services Command Reference.

Cables and connectors

74 ■ SONET/SDH OC3c/STM1 PIC

T1600 Internet Routing Node PIC Guide

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 112 113

Comments to this Manuals

No comments

Juniper Networks T1600 User Manual Page 74

Comments to this Manuals

Related products and manuals for Routers Juniper Networks T1600