Juniper Networks T1600 User Manual download pdf (Page 32)

Installing a T1600-SIB

Each SIB weighs approximately 6.5 lb (3 kg). To install a T1600-SIB, follow this

procedure (see Figure 20 on page 32):

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and

connect the strap to one of the ESD points on the chassis. See “Preventing

Electrostatic Discharge Damage” on page 47.

2. Place one hand underneath the T1600-SIB to support it. With the other hand,

hold one of the ejector handles on the T1600-SIB faceplate.

3. Carefully align the sides of the T1600-SIB with the guides inside the chassis.

4. Slide the T1600-SIB into the chassis, carefully ensuring that it is correctly aligned.

5. Grasp both ejector handles and press them inward to seat the T1600-SIB. Ensure

that the ejector handle tabs are properly mated inside their corresponding chassis

slots. You might have to close and open the handles a few times before the tabs

catch the slots.

6. Tighten the captive screws on the ejector handles.

7. Bring the T1600-SIB online using one of the following methods:

■

Press and hold the ONLINE/OFFLINE button on the T1600-SIB faceplate. The

green OK LED on the faceplate begins to blink. Hold the button down until

the LED blinks.

■ Issue the following CLI command on the routing node:

user@host> request chassis sib online slot 0

Figure 20: Installing a T1600-SIB in a T1600

g002406

32 ■ Upgrading SIBs

T1600 Routing Node Upgrade Guide

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 55 56

No comments

Juniper Networks T1600 User Manual Page 32