Juniper Networks T1600 User Manual download pdf (Page 33)

Verifying the Installation of a T1600-SIB

To verify that the T1600-SIB is functioning normally, follow this procedure:

1. Check the LEDs on the T1600-SIB faceplate.

■

The green OK LED should light steadily a few minutes after the T1600-SIB

is installed.

■

If the FAIL LED is lit steadily, remove and install the T1600-SIB again. Make

sure that the T1600-SIB is seated properly. If the FAIL LED still lights steadily,

the T1600-SIB is not functioning properly. Contact your customer support

representative.

Verify that four T1600-SIB are in the Online state and one SIB is in the Spare

state. Display the status of the T1600-SIB by issuing the show chassis sibs

command:

user@host> show chassis sibs

Slot State Uptime

0 Spare 0 days, 30 minutes, 12 seconds

1 Online 0 days, 25 minutes, 45 seconds

2 Online 0 days, 20 minutes, 28 seconds

3 Online 0 days, 15 minutes, 7 seconds

4 Online 0 days, 10 minutes, 52 seconds

To bring a T1600-SIB online, issue the request chassis sib online operational

mode command.

Preparing to Exit Upgrade Mode

After all five T1600-SIBs have been installed, use the following commands to exit

upgrade mode :

1. Determine if GRES is enabled.

user@host> show system switchover

Graceful switchover: On

Configuration database: Ready

Kernel database: Ready

Verify that the Routing Engines are operating properly by issuing the show chassis

routing-engine command.

user@host> show chassis routing-engine

Routing Engine status:

Slot 0:

Current state Master

Election priority Master (default)

Temperature 32 degrees C / 89 degrees F

CPU temperature 33 degrees C / 91 degrees F

Upgrading SIBs ■ 33

Upgrading SIBs

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 55 56

No comments

Juniper Networks T1600 User Manual Page 33