Juniper Networks T1600 User Manual download pdf (Page 27)

■

Multiprotocol Label Switching (MPLS) circuit cross-connect for leveraging ATM access

networks

■

User-configurable virtual circuit (VC) and virtual path (VP) support

■

Support for idle cell or unassigned cell transmission

■

OAM Fault Management processes Alarm Indication Signal (AIS), Remote Defect Indicator

(RDI), and loop cells

■

Point-to-point and point-to-multipoint mode Layer 2 counters per VC and per VP

■

Local and remote loopback

■

ATM Inverse ARP, which enables routers to automatically learn the IP address of the

router on the far end of an ATM PVC

■

Simple Network Management Protocol (SNMP):

■

Management Information Base (MIB) 2 (RFC 1213)

■

ATM MIB (RFC 1695)

■

SONET MIB

■

Unspecified bit rate (UBR), non-real-time variable bit rate (VBR), and constant bit rate

(CBR) traffic shaping

■

Per-VC or per-VP traffic shaping

■

Support for F4 OAM cells

■

Support for 16-bit VCI range

Software features

■

You can install different transceivers on the PIC. For information about installing and

removing transceivers, see the PIC and Transceiver Installation Instructions.

■

Duplex SC/PC connector (RX and TX)

■

Optical interface support—see Table 17 on page 27

Cables and connectors

One tricolor per port:

■

Off—Not enabled

■

Green—Online with no alarms or failures

■

Amber—Online with alarms for remote failures

■

Red—Active with a local alarm; router has detected a failure

LEDs

■

Alarm indication signal (AIS-L, AIS-P)

■

Bit error rate signal degrade (BERR-SD), bit error rate signal fail (BERR-SF)

■

Bit interleaved parity errors B1, B2, B3

■

Errored seconds (ES-S, ES-L, ES-P), far-end bit errors REI-L, REI-P (CV-LFE, CV-PFE),

far-end errored seconds (ES-LFE, ES-PFE), far-end severely errored seconds (SES-LFE,

SES-PFE), far-end unavailable seconds (UAS-LFE, UAS-PFE)

■

Loss of cell delineation (LOC), loss of frame (LOF), loss of pointer (LOP-P), loss of signal

(LOS)

■

Payload mismatch (PLM-P), payload unequipped (UNEQ-P)

■

Remote defect indication (RDI-L, RDI-P)

■

Severely errored framing (SEF), severely errored framing seconds (SEFS-S), severely

errored seconds (SES-S, SES-L, SES-P), unavailable seconds (UAS-L, UAS-P)

Alarms, errors, and

events

Table 17: Optical Interface Support for ATM2 OC48/STM16 IQ PICs

MultimodeIntermediate Reach (IR)Optical Parameter

MultimodeSingle-modeOptical interface

ATM2 OC48/STM16 IQ PIC with SFP ■ 27

ATM2 OC48/STM16 IQ PIC with SFP

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 112 113

Comments to this Manuals

No comments

Juniper Networks T1600 User Manual Page 27

Comments to this Manuals

Related products and manuals for Routers Juniper Networks T1600