Juniper Networks T1600 User Manual download pdf (Page 78)

■

Optical diagnostics and related alarms

■

Per-port SONET/SDH framing

■

Link aggregation

■

Alarm and event counting and detection

■

Dual-router automatic protection switching (APS)

■

Multiprotocol Label Switching (MPLS) fast reroute

■

Encapsulations:

■

High-Level Data Link Control (HDLC)

■

Frame Relay

■

Circuit cross-connect (CCC)

■

Translational cross-connect (TCC)

■

Point-to-Point Protocol (PPP)

Software features

You can install any transceiver supported by the PIC. For information about installing and

removing transceivers, see the PIC and Transceiver Installation Instructions.

■

Duplex LC/PC connector (Rx and Tx)

■

Optical interface support—See Table 32 on page 79 and Table 33 on page 80

NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid

links, take the PIC offline until you are ready to establish a link to another device. For

information about taking a PIC offline, see the request chassis pic offline command in the

JUNOS System Basics and Services Command Reference.

Cables and connectors

One tricolor per port:

■

Off—Not enabled

■

Green—Online with no alarms or failures

■

Amber—Online with alarms for remote failures

■

Red—Active with a local alarm; router has detected a failure

LEDs

78 ■ SONET/SDH OC3/STM1 (Multi-Rate) PICs with SFP

T1600 Internet Routing Node PIC Guide

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 112 113

Comments to this Manuals

No comments

Juniper Networks T1600 User Manual Page 78

Comments to this Manuals

Related products and manuals for Routers Juniper Networks T1600