Juniper Networks T1600 User Manual Page 46

  • Download
  • Add to my manuals
  • Print
  • Page
    / 113
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 45
You can install any transceiver supported by the PIC. For information about installing
and removing transceivers, see the PIC and Transceiver Installation Instructions.
Fiber-optic SFP transceivers:
Duplex LC/PC connector (Rx and Tx)
Optical interface supportSee Table 20 on page 46
1000Base-T SFP transceivers:
Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45
connector
Pinout: MDI crossover
Length: 328 ft/100 m
NOTE: Do not install Gigabit Ethernet SFPs in the SONET/SDH port. The port will not recognize
the SFP.
Cables and connectors
Status LED, one bicolor:
OffPIC is not enabled
GreenPIC is operating normally
RedPIC has an error or failure
Port LEDs, one pair per port:
LinkIf green, the port is online; if there is no light, the port is down
ActivityIf flashing green, the port is receiving data; if there is no light, the port might
be on but is not receiving data
LEDs
Table 20: Optical Interface Support for Gigabit Ethernet PICs with SFP
1000Base-LH1000Base-LX1000Base-SXParameter
Single-modeSingle-modeMultimodeOptical interface
SFPSFPSFPTransceiver type
9/125 SMF cable:
43.5 miles/70 km
9/125 SMF cable:
6.2 miles/10 km
62.5/125 and 50/125
MMF cable:
1804.5 ft/550 m
62.5/125 MMF cable:
656 ft/200 m
50/125 MMF cable:
1640 ft/500 m
Maximum distance
1355 through 1580 nm1270 through 1355 nm770 through 860 nmTransmitter wavelength
3 through +3 dBm11.5 through 3 dBm9.5 through 0 dBmAverage launch power
20 through 3 dBm19 through 3 dBm17 through 0 dBmAverage receive power
3 dBm3 dBm0 dBmReceiver saturation
20 dBm19 dBm17 dBmReceiver sensitivity
46 Gigabit Ethernet PICs with SFP
T1600 Internet Routing Node PIC Guide
Page view 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 112 113

Comments to this Manuals

No comments